Set SushiSwap Slippage by Checking the Minimum You’ll Receive

Set slippage for your first SushiSwap swap by choosing the largest price change you will accept before the trade fails. The app’s quote estimates how many tokens you’ll receive; your tolerance sets a lower limit on that amount. If the market moves past the limit before the transaction executes, the swap should revert instead of completing at a worse rate.

First choose the network and the tokens, then enter the amount to swap. The interface finds a route through one or more liquidity pools and shows an estimated output. Open the swap settings, usually through a settings or gear icon, and review the slippage control. For a closer look at the relationship between Sushi’s fee flows, reserves and liquidity, see sushiswap. The setting protects the execution of your trade; it does not guarantee the quoted price.

What does slippage tolerance change?

Slippage tolerance sets the minimum output your swap can accept. The quote is a snapshot: other trades can change pool prices while your transaction waits to be included on-chain. The tolerance gives that price room to move. In a typical exact-input swap, a wider tolerance lowers the minimum output; a narrower one raises it.

For example, if a quote estimates 100 output tokens and you set a 1% tolerance, the minimum is 99. The trade can execute at 99 or more. If the available output falls below 99 before execution, it fails. Think of the limit as a reservation with a floor: the trade proceeds only if the final amount clears it.

That floor is not a prediction of how much the price will move. It also does not remove price impact, the effect your own trade has on the pool price. A large swap against a shallow pool can already have a poor quote before you submit it. Slippage tolerance allows additional movement after that quote.

How should you choose a first setting?

Start with the app’s automatic setting if it offers one. If you choose manually, use the narrowest tolerance that still gives the trade room to execute. There is no universal percentage: a liquid, stable pair may need less room than a volatile token or a thin pool. Check the quote and the minimum received together before deciding.

• Read the estimated output and any price-impact warning before adjusting settings.
• Check the minimum received after you select a tolerance. That figure makes the trade-off concrete.
• If the setting is manual, enter a modest limit that fits the asset and pool conditions you see.
• If a swap fails, review the quote and pool conditions again before considering a small increase.

A failed swap can mean the price crossed your limit, but it can also reflect a stale quote or another transaction issue. Don’t keep raising tolerance just to force execution. A high limit lets the trade accept a lower output than you may expect, and it cannot fix a bad route or an unfavorable quote. If the minimum received looks too low, cancel the attempt and reassess the trade.

What should you check before confirming?

Before signing, confirm the token names, network, input amount, estimated output and minimum received. Make sure the wallet is connected to the network shown by the swap page. If the interface shows a route or price impact, inspect it; the route can pass through several pools, and the quote reflects the full path.

Then submit the swap and review the transaction in your wallet. The wallet confirmation is a separate step from the page’s quote: check what you are authorizing and the network fee before signing. Once submitted, the transaction may take time to confirm. The slippage limit still applies at execution, so a market move beyond it can cause the transaction to fail.

For a first swap, a sensible setting is the smallest tolerance that accommodates the conditions shown by the quote. Watch the minimum received, not just the headline estimate. That is the amount the transaction is designed to protect.